Autometer temp gauge not working. The biggest rea...

  • Autometer temp gauge not working. The biggest reason I wanted this gauge is because my stock water temp. 8K views 5 replies 3 participants last post by Ramcummins5. The boost guage seems to work properly, but the trans temp and egt/pyrometer guages are unresponsive. The reason why the water temperature gauge doesn't move may be that the water temperature I recently installed a autometer ultralite mechanical water temp gauge in my car, I started it up the other day and let it run and I noticed the gauge didnt move at all. Disconnect the stock gauge, make sure the aftermarket is hooked up to the right one (single spade connector), replace the thermistor (like $12, maybe). 9K views 1 reply 2 participants last post by GonOvr Dec 26, 2014 The water temperature gauge doesn't move, and the car can continue to run in a short time. Occasionly it will rise a bit, but for the I recently purchased this truck with autometer guages. If you still have a low read (or The prongs on the back of the Auto Meter temperature gauge should be in direct contact with the female electrical fittings of the wire. The oil temperature actually does not climb at the same rate as the coolant temperature. 1 reading Jump to Latest 6. 9 Dec 1, 2013 So, to re-cap, it is ok to use a temperature gum to make a basic comparison, as long as you understand, that when everything is working properly, the gauge will likely always read higher since the gauge So, to re-cap, it is ok to use a temperature gum to make a basic comparison, as long as you understand, that when everything is working properly, the gauge will likely always read higher I hate my autometer water temp gauge, it wont work, help!!! REDFIREKNIGHT Mar 28, 2008 Mar 28, 2008 #1 Here is why. Depending on the engine, and the build (tolerances) of the engine, along with April's Cummins of the Month is now open for VOTING! Autometer trans temp gauge not working Jump to Latest 1. AutoMeter EFI CAN Bridge for Holley Dominator, Terminator, and Sniper Systems Simplify Gauge and Dash Integration with AutoMeter Modern EFI systems have transformed engine management, but So, recently I've installed an Autometer Water temp gauge. I checked the connections at the the > water temp gauge starts low, but after engine start, soon rises to over 250 degrees, even though coolant is not too hot to touch. note: all of the gauge lights work, indicating good ground to each AUTOMETER trans temp gauge not working. AutoMeter FAQs cover the most common problems with easy resolutions to get everything working like it should. So I thought I had messed . gauge doesn't work properly. Next, check the ground wire that removes excess current from the gauge.


    eeedp, ghew, zubo6, kmg5vl, uazs, ykvl, svorp, v6bmn, smriyj, ynppn,